![network is unreachable linux virtualbox network is unreachable linux virtualbox](https://forum.linuxconfig.org/uploads/db3649/original/2X/9/97eced4d470ee75881e4c39d61d80b12fac0c434.png)
![network is unreachable linux virtualbox network is unreachable linux virtualbox](https://static.thegeekstuff.com/wp-content/uploads/2012/03/vb-storage-settings.png)
Link/ether 52:54:00:84:8b:61 brd ff:ff:ff:ff:ff:ffĦ: virbr0-nic: mtu 1500 qdisc pfifo_fast master virbr0 state DOWN mode DEFAULT qlen 500 Link/ether 08:00:27:da:2c:5b brd ff:ff:ff:ff:ff:ffĥ: virbr0: mtu 1500 qdisc noqueue state DOWN mode DEFAULT Link/ether 08:00:27:0c:da:7c brd ff:ff:ff:ff:ff:ffĤ: enp0s9: mtu 1500 qdisc pfifo_fast state UP mode DEFAULT qlen 1000 Link/ether 08:00:27:a1:f1:81 brd ff:ff:ff:ff:ff:ffģ: enp0s8: mtu 1500 qdisc pfifo_fast state UP mode DEFAULT qlen 1000 Desktop]# ip link showġ: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT However, we already know they are in disconnected state after checking the device status with nmcli. We can further verify the link status of the adapter and the IPs associated with them. TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0Įther 08:00:27:0c:da:7c txqueuelen 1000 (Ethernet)Įther 08:00:27:da:2c:5b txqueuelen 1000 (Ethernet) To get the further status of the network we use the ifconfig as shown below. We will be proceeding ahead with their configuration. Also in the above list that all these devices are currently in the disconnected state. The 3 network adapters that we currently have are listed below with their mapping to the types which were attached to the VM. The above list shows the network devices and their status. For this, we use the Linux networking tool nmcli. We have to login as root to carry ahead with the network configuration.Ĭheck the currently available devices. The types of the network configured on the VM are:Īfter the adapters are configured in the VM the setup is being carried out after login into the host VM. I have currently 3 Network interfaces attached to my OL 7 VM.